Features

Valspar Duramax Elastomeric Masonry & Stucco Paint forms a weatherproof barrier against nature's harsh extremes. Stucco and masonry structures expand and contract in response to the weather and structural stresses. Unlike typical exterior paints, this coating fills and bridges hairline cracks, helping to prevent damaging water penetration. It passes Federal Specification TT-C-555B, sec. 3.3.3, withstanding 98 mph wind-driven rain. This premium quality coating protects your home like a flexible blanket keeping your masonry and stucco safe and beautiful for years to come. It is available in white and can be tinted to many custom colors to make your home a showplace!

Coverage

Apply two coats of product to ensure best coverage and proper overall performance. On smooth surfaces, a gallon can cover 130 sq. ft. (10' x 13' area). On rough or uneven surfaces, it covers 90 sq. ft. per gallon. (NOTE: For two coats, you need a gallon for every 45-65 sq. ft.).

Where to Use

Use on properly prepared exterior masonry surfaces including cement, cinder block, stucco, concrete and brick. Do not use on glazed brick, floors or steps. Wait a month before applying to new concrete or stucco.

Preparing the Surface

Large cracks or crumbling areas or water damage, may need professional repair. Apply paint to clean, sound surfaces. Remove dirt, grease, mildew, algae, efflorescence and loose, peeling coating. Clean Mildew from the Surface: To remove mildew or suspected mildew, scrub house before painting with a commercial mildew remover or a solution of 1 part liquid chlorine bleach to 3 parts water. Rinse thoroughly. Avoid contact with skin or eyes. Pressure washer and masonry and stucco cleaner will ensure a clean, chalk and dirt free surface. Follow all label and equipment instructions and rinse well. Caution: Improper power washer use may cause damage to stucco. Priming is not required on masonry surfaces in sound or good condition (cured, no efflorescence, etc.). Caulk all joints, seams and cracks around windows, doors and trim to eliminate sources of moisture entry.

Dry Time

Dries to the touch in 1-2 hours, longer in high humidity or cool temperatures. Paint when surface and air temperatures are 35-90°F (2-32°C). Allow to dry overnight before recoating. Lead Warning (see below)

Warning!

Warning! If you scrape, sand or remove old paint, you may release lead dust. LEAD IS TOXIC. EXPOSURE TO LEAD DUST CAN CAUSE SERIOUS ILLNESS, SUCH AS BRAIN DAMAGE, ESPECIALLY IN CHILDREN. PREGNANT WOMEN SHOULD ALSO AVOID EXPOSURE. Wear a NIOSH-approved respirator to control lead exposure. Clean-up carefully with a HEPA vacuum and wet mop. Before you start, find out how to protect yourself and your family by contacting the National Lead Information Hotline at 1-800-424-LEAD or log onto www.epa.gov/lead.