Actual color may vary from on-screen representation.
Valspar® StormCoat® Exterior Paint
Valspar® StormCoat® is a 100% acrylic, professional-quality, exterior latex paint developed to resist cracking and peeling. It can be applied at temperatures as low as 35 °F, allowing you to extend the painting season. StormCoat provides a smooth, uniform finish with spray, brush or roller application and can be applied to a variety of exterior surfaces: wood and metal siding, trim including hardboard, fiber cement board, vinyl, shakes, primed metal, brick, cement and cured cinder block and stucco.
Paint Sheen Comparison
Available sheens for this product
Flat, Satin, Semi-Gloss
1 Gallon, 5 Gallon
HOW TO USE
UsageBest for walls and siding, this product applies easily to properly prepared and primed wood, drywall and vinyl or aluminum siding, as well as properly cured stucco, concrete or cement composition siding/panels.
PrepThoroughly clean the surface and allow to dry. Remove all wax, grease, dirt, chalk, mildew, loose and peeling paint, and other foreign matter. Remove gloss from shiny surfaces. Fill all cracks and joints with Acrylic caulk before top coating. Remove any powdery dust and efflorescence. New or bare surfaces should be primed with an appropriate Valspar® primer.
ApplicationStir paint thoroughly. Intermix containers to ensure uniform color. Apply with a premium-quality roller, polyester brush or airless sprayer. Paint the ceiling first, then the walls. If applying by roller, roll from dry area into wet area using firm, crisscross strokes. Finish with long, even strokes in one direction. Note: Some deep or bright colors may require an additional coat to obtain complete hide. Surface conditions and application technique can also impact coverage.
Dry TimeDry Time @ 77 °F and 50 % Relative HumidityTo The Touch: 1 hour - 2 hour Recoat: 4 hour - 24 hour
Clean-up & DisposalClean up with warm, soapy water