Actual color may vary from on-screen representation.
Valspar® Cabinet and Furniture Oil-Enriched Enamel
Valspar Cabinet and Furniture Paint dries to a smooth factory-like finish and stands up to daily use leaving a fade-, scratch-, and scuff resistant finish. Most projects will require little-to-no prep work. The oil-enriched formula provides exceptional durability with no brush marks.
Paint Sheen Comparison
Available sheens for this product
Flat, Satin, Semi-Gloss
1 Quart, 1 Gallon
HOW TO USE
UsageProperly prepared or previously painted interior and exterior doors, trim and cabinets.
PrepPreviously Painted Surfaces: Thoroughly clean the surface and allow to dry. Remove all dirt, dust, chalk, rust, grease, wax and mildew. Scrape off loose and peeling paint. Dull glossy surfaces by sanding. Bare Wood, Plywood/Composition Board: For best results over heavily stained areas and bleeding woods such as redwood and cedar, use a coat of stain-blocking primer. Metal: Remove rust on galvanized surfaces and prime with a rust-inhibitive metal primer. For drastic color changes or deep, vivid colors, prime with this product or an appropriate tintable primer for your optimal color accuracy and coverage. Clean Mildew from the Surface: Mildew is a fungus that looks like dirt, but won’t wash off. Mildew must be removed before painting or it will grow through any new coat of paint. To remove mildew or suspected mildew, scrub surface before painting with a commercial mildew remover or a solution of 1 part liquid chlorine bleach to 3 parts water. Rinse thoroughly. Avoid contact with skin and eyes. Protect skin and eyes by wearing rubber gloves and eye goggles when working with bleach solution.
ApplicationStir paint thoroughly. Intermix containers for uniformity. Apply product when surface, air and product temperatures are between 50-90°F. Apply with a premium-quality brush, a synthetic roller cover or airless spray. Thinning not required. Finish with light roller strokes in one direction. Certain deep or bright colors may require an additional coat for complete hide. Surface conditions and application technique may impact coverage.
Dry TimeDry Time @ 77 °F and 50 % Relative HumidityTo The Touch: 2 hour - 4 hour Recoat: 4 hour
Clean-up & DisposalClean up with warm, soapy water. If product has fully dried, you may need mineral spirits.